| 12volts |
lt. blue/red (15A) | + | ignition harness |
| Starter |
pink/dk. green | + | ignition harness |
| Second Starter |
purple/brown | - | ignition harness |
| Notes: The second starter wire is negative trigger thru an 180 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information. |
| Ignition |
pink/white | + | ignition harness |
| Second Ignition |
| | |
| Third Ignition |
| | |
| Accessory |
same as second starter wire | - | ignition harness |
| Notes: The accessory wire is negative trigger thru a 610 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information. |
| Second Accessory | | | |
| Keysense | | | |
| Power Lock | purple/dk. green | - | DKP or cluster, gry 26P plug, pin 5 |
| Notes: Lock is negative trigger thru a 330 ohm resistor. Unlock is negative trigger thru a 100 ohm resistor. MUST use relays. |
| Power Unlock | same as power lock wire | | |
| Lock Motor | lt. green | 5wi | DKP or cluster, gry 26P plug, pin 12 |
| Unlock Motor | tan/lt. green | 5wi | DKP or cluster, gry 26P plug, pin 11 |
| Parking Lights+ | white/purple | + | pass. kick, brn 26 pin plug, pin 26 |
| Parking Lights- | white/brown | - | sw or cluster, gry 26P plug, pin 3 |
| Notes: Parking lights are negative trigger thru an 1,670 ohm resistor. There is a rest resistance on the wire, so must use a relay to isolate from the switch. |
| Hazards | white/dk. blue | - | hazard switch |
| Turn Signal(L) | use hazards wire | | |
| Turn Signal(R) | use hazards wire | | |
| Reverse Light | white/lt. green | + | pass. kick, brn 26 pin plug, pin 17 |
| Door Trigger | see notes | - | each kick or instrument cluster |
| Notes: The LF door is purple in the white plug, pin 3. The RF door is purple/white in the white plug, pin 3. The LR door is purple/gray in the gray 26 pin plug, pin 10. The RR door is purple/yellow in the gray 26 pin plug, pin 9. Use all four wires and diode isolate each. |
| Dome Supervision | yellow/white | + | instrument cluster, wht plug, pin 12 |
| Notes: Also found in the passenger side A pillar. |
| Trunk/Hatch Pin | purple/orange | - | PKP or cluster, gry 26P plug, pin 23 |
| Hood Pin | purple/lt. blue (export only) | - | pin switch under hood |
| Trunk/Hatch Release | purple/tan | - | sw or cluster, gry 26P plug, pin 22 |
| Power Sliding Door | N/A | | |
| Factory Alarm Arm | arms on lock with door open | | |
| Factory Alarm Disarm | factory remote only | | |
| Disarm No Unlock | with ignition and Sentry Key | | |
| Tachometer | NOT brown/yellow | ac | any ignition coil or fuel injector |
| Wait to start | N/A | | |
| Brake Wire | dk. green/white | + | brake pedal switch |
| Parking Brake | gray/black | - | sw or cluster, gry 26P plug, pin 18 |
| Horn Trigger | dk. green/orange | + | horns under hood |
| Memory Seat 1 | purple/brown | - | memory switch in driver door |
| Notes: Memory seats are negative trigger thru resistors. The resistor values are not known at this time. Cut the wire and meter the values as you press the memory 1 and memory 2 buttons. |
| Memory Seat 2 | same wire as memory seat 1 | - | |
| Memory Seat 3 | N/A | - | |
